BX-PIB0x Embedded Box System
19
2.3.2 Installing a CPU
1. Remove the four screws securing the heat pipe assembly to each side
of the chassis.
2. Remove the five screws securing the main heat spreader to the COM
Express module.
3. Carefully lift the thermal module assembly out of the chassis, being
careful not to bend the heat pipes.
4. Remove any protective films from the heat spreader as required.
5. Install the CPU.
5. Replace the thermal module assembly into the chassis and reverse the
steps above to secure it.
CAUTION:
Check that the thermal pads have not been damaged. Improper
thermal contact between the heat spreader and heat sink may
result in overheating and damage to the system.
Commentaires sur ces manuels